Data Sheet

In this next screenshot, you can see it has got a packet from the Dexcom transmitter. The
wixel waits until it has a BLE connection to the phone, then it sends a beacon, then the
DATA packet, and waits for an ACK packet.
Once it has this, it saves the settings to flash (mo message above) and then goes to sleep.
It is relatively common for the current xDrip app to take a while to establish a connection.
Hence you can see all the “packet waiting” messages here. The wixel will stay awake for
two minutes after a packet capture, waiting for a BLE connection. On some occasions, this
will not happen, the wixel will once again go to sleep, and this will appear as a missed
packet in xDrip.
At any time when the wixel is awake, you can press the “S” key on the keyboard to get a
status display. See below.