Data Sheet

Example Output on USB Serial Port
The screen shot above shows a boot up after the firmware is loaded. Note, that this wixel
was already joined to an xDrip app. As you can see, when it first started up, all the
xBridge_flags were set to 1 (ffff). After the HM-1x was set and configured, the flags are now
set to fffe. Also, the battery_minimum and battery_maximum settings are not yet set
(showing 65535).
After it has configured the HM-1x it sends a beacon packet until it gets a TXID packet in
response. Once it has received the TXID, it saves all the settings to flash, and begins
scanning the radio channels for a packet.