Manual

CHAPTER 1
You can tie several servos together so that when you move one the other ones all move as well. To do
this click on the Group control for each of the servos and set it to the same number. When you move
one of them all the others will move in sync.
Servo Configuration
Across the top of the servo controls you'll see a toolbar with a number of buttons on it.
From here you can perform a number of operations that affect the configuration of all servos. You can
center them all and switch them all on or off with one click. You can also reset all servos to their
standard default settings.
The disk button allows you to save and load servo configurations for use in the future. This is handy if
you have created a servo setup for a particular application that you use often.
- 8 -