Manual

Choose the correct COM port associated with the Rover or the XB/BT board
The name DFRobotShop Rover is not necessary; you can name it whatever you want.
Specify the COM port (USB) that is connected to the DFRobotShop Rover. If you are using XBee, Bluetooth or RF,
select the COM port connected to the Bluetooth dongle / XBee breakout / RF Transmitter (USB).
No configuration is needed for the DFRobot Bluetooth Module simply connect to it via your Bluetooth
application and the module installed on the DFRobotShop Rover will be picked up (assuming it is powered).
To use the XBee modules, install one on the USB to XBee breakout board in the same orientation as indicated
on the board, and connect the board via USB to your computer. The board should be picked up as a standard
COM port. Install the other XBee module on the XBee shield and install the shield on the board ensuring the
Tx/Rx pins of the shield line up with Rx/Tx pins on the DFRobotShop Rover PCB.