Manual

but note that the onboard charger can only provide 4.3V charge current, so it won't charge a
7.4V LiPo.
4. Vin pin : An Arduino board can be powered using the Vin pin located to the left of the A0 pin. However,
this pin is not connected to a regulator and we do not suggest using it to power the DFRobotShop
Rover.
Motion
The DFRobotShop Rover Basic Kit uses two tank tracks, each connected to their own DC gear motor. Rotating
the tracks at the same time in the same direction produces forward motion. Rotating the tracks at the same
time in the opposite direction causes the robot to move in reverse. Varying the speed of one of the tracks will
cause the robot to move in a circle. Rotating the tracks in opposite directions causes the robot to turn clockwise
(or counter-clockwise) on itself (zero turning radius).
Specifications (Basic Kit)
• Maximum speed (using 4x AA NiMH batteries and motor config. 'C'): 12.5cm/sec (no load)
• PCB Dimensions: 57mm x 195mm (200mm for V2.0)
• Overall dimensions: 200mm long x 108mm wide x 58mm high
Weight (assembled kit not including batteries): 250g