User's Manual

- 5 -
3. First touch the computer metalwork with your hand to drain any static
charge, then carefully insert the card into the vacant slot and push down
until it is firmly seated. Screw the metal bracket at the end of the card to
the computer case.
(This must be done to provide proper grounding for
the card)
.
4. Replace the computer case and reconnect the power cord.
5. Connect the supplied audio lead between the receiver output (a
standard audio jack) and the sound card Line Input.
(If there is no Line
input on your PC, as is the case with some laptops, you may use
alternative inputs, such as the Microphone input.)
6. Connect the supplied start-up antenna to the SMA connector at the rear
of the card.
7. Extend the antenna so that it is as far away from the computer as
possible.
Please use only the WiNRADiO-supplied audio lead cable to connect the
receiver to the sound card. This is a stereo cable (as is the case with all
standard PC multimedia cables). Mono jacks are not compatible with stereo
ones because they short the right channel to ground. A mono cable should
not be used under any circumstances and will not work with the G3 SERIES
receiver.
Software Installation
1. After installing the card, turn the PC on. Windows will find the card and
automatically start the usual
New hardware found
driver installation
routine. Insert the installation CD ROM into the drive, and follow on-
screen instructions.
(Note: Windows NT will not automatically detect the
card, as it does not support Plug and Play.)
2. After installing the drivers, choose the
Run
command from the
Start
menu in Windows and type D:INSTALL (if the CD ROM is the D: drive
on your PC).
3. This will run the application installer, which will guide you in the
installation process.
4. After all the files have been installed to your hard disk, run the
WiNRADiO G3 SERIES application.