User's Manual

- 30 -
Note that the upper scanning speed limit may be restricted by the actually
available CPU resources of your computer.
When signal is found and scanning pauses, waiting for the pre-
set Delay
time
to expire, the countdown timer will appear inside the [<<] or [>>]
buttons. If no
Delay time
was set and scanning is pausing until the signal
disappears, then the [<<] or [>>] button will flash.
Groups
The
Groups
setting is useful for Memory Scanning, which will be described
later: it serves to restrict Memory Scanning to particular memory groups
only.
Exclusions
Sometimes it is desirable to exclude certain frequencies from scanning. This
means that such specified frequencies should be ignored even if the signal
level on these frequencies is higher than the squelch.
The WiNRADiO G3 SERIES receiver application makes it possible for
multiple frequency ranges to be excluded. This is done using the
Exclusions
button. When you press this button, you will open an
Exclusions editor
window, allowing you to enter a range of frequencies to
be excluded.
For these exclusions to become active, check the
Enable excluding while
scanning
checkbox in this window.
Frequency Range Scanning
To be able to use Frequency Range Scanning, you need to set up the
desired scanning ranges first. This is done using the
Ranges
button in the
Options | Scanning
top-bar menu.
Did you know?
Unlike medium wave or FM broadcast stations, shortwave stations change
their frequencies and program schedules very often. One of the best
publications providing regular frequency updates and transmitting schedules
is the
Monitoring Times
magazine (www.monitoringtimes.com).