User manual

PAGE 8
BIGMOW
Technical Specifications.
Once installation is complete, you get start your
new automatic lawnmower: the Bigmow. Depend-
ing on its mowing mode (automatic or system-
atic) and its programme, the Bigmow will start
mowing the lawn.
When it encounters an obstacle (minimum height
16 in), its sonar will instruct it to slow down and,
on contact with the obstacle, its various sensors
will instruct it to stop, reverse, change direction
and continue to mow the lawn.
The Bigmow will also systematically mow the
thicker areas of the lawn, and it will do so auto-
matically.
The Bigmow will instantly recharge when his bat-
teries fall below the minimum charge level. It
moves in the direction of the peripheral wire and
follows it in the right direction towards the re-
charging station. After recharging fully, the Big-
mow automatically resumes mowing the lawn.
When the lawn does not need mowing, the Big-
mow remains at its recharging station and re-
sumes mowing later. It only works when required
to do so.
** There are 12 manual incremental positions for
height control. The height is changed by 0.25 inch
General Operation
Cutting system 5 discs with 3 blades
Cutting height From 0.75 in. To 3.75 in **
Cutting disk motor 3 phases, 24 Volts, 50 Watts
Rotation speed 3700 RPM
Back wheel motor 24 Volts, 50 Watts
Maintenance capacity 5 acres, +- 20%
Mowing speed 3600 sq yds.
Weight 105 pounds
Length 51.2 in.
Height 19.7 in.
Width 47.2 in.
Recharging station 30 Volts AC
Peripheral wire 0.5 Volts, 50mA
Transformer 230 / 15 V, double insulation
Consumption 100w/h