Data Sheet

SBL13xx Motor Controller Datasheet 13
Electrical Specifications
Thermal Specifications
TABLE 9.
Parameter Measure Point Min Typical Max Units
Board Temperature PCB -40 85 (1) ºC
Thermal Protection range PCB 70 80 (2) ºC
Thermal resistance Power MOSFETs to heats sink 2 ºC/W
Note 1: Thermal protection will protect the controller power
Note 2: Max allowed power out starts lowering at minimum of range, down to 0 at max of range
The SBL13xx uses a conduction plate at the bottom of the board for heat extraction. For best results, attach firmly with
thermal compound paste against a metallic chassis so that heat transfers to the conduction plate to the chas sis. If no
metallic surface is available, mount the controller on spacers so that forced or natural air flow can go over the plate
surface to remove heat.
Mechanical Specifications
TABLE 10.
Parameter Measure Point Min Typical Max Units
Weight Board 96 (.21) g (lbs)
Power Wire Gauge Screw Terminals 12 AWG
17.2mm
5.6mm
25.6mm
0.68”
0.22”
1.0”
FIGURE 12. SBL13xx Front View and Dimensions