Manualshelf

Data Sheet

ManualsBrandsRoboteQ ManualsBrushless DC Motor ControllersRoboteQ FDC3260 3x40A 7-60V Robot Controller
12345678910
FDC3260 Motor Controller Datasheet 3
Power Wires Identifications and Connection
Important Safety Disclaimer
Dangerous uncontrolled motor runaway condition can occur for a number of reasons, including, but not
limited to: command or feedback wiring failure, configuration error, faulty firmware, errors in user script or
user program, or controller hardware failure.
The user must assume that such failures can occur and must make his/her system safe in all conditions.
Roboteq will not be liable in case of damage or injury as a result of product misuse or failure.
Power Wires Identifications and Connection
Power connections are made by means of faston tabs located at the back of the controller.
The diagram below shows how to wire the controller and how to turn power On and Off.
I/O ConnectorHall Sensors
Connector
USB
Connector
LEDs
FIGURE 1. FDC3260 front view
Pwr
CtrlVMOT
GND M1+
M1-M2+M2-M3+
M3-
FIGURE 2. FDC3260 rear view