Manualshelf

Data Sheet

ManualsBrandsRoboteQ ManualsBrushless DC Motor ControllersFBL2360S 60V 1x75A Brushless DC Motor Controller
12345678910
FBL2360 Motor Controller Datasheet 5
Single Channel Wiring
Note 5: Connect the controller’s bottom plate to a wire connected to the Earth while the charger is plugged in the
AC main, or if the controller is powered by an AC power supply.
Note 6: Beware not to create a path from the ground pins on the I/O connector and the battery minus terminal.
Single Channel Wiring
On the Single Channel FBL2360S, the each of the motor wire must be connected to both output tabs of the same
letter as shown in the figure below. Use the Encoders and/or Hall sensors of Channel 1 for operation.
Important Warning
This wiring must be done only on the single channel version of the controller. Paralleling the wires on a dual
channel product will cause permanent damage. Verify that your controller is an FBL2360S before you wire
in this manner.
U1
V1
W1
U2
V2
W2
U
V
W
FIGURE 4. Single Channel wiring diagram