Manualshelf

Data Sheet

ManualsBrandsRoboteQ ManualsR/C DC ControllersRoboteQ FBL2360A 2x40A 7-60V Robot Controller (Header for Ethernet)
891011121314151617
FBL2360 Brushless DC Motor Controller Datasheet 13
Electrical Specifications
Measured and Calculated Amps
Including Amps sensors on the wires allows for fast and efficient gathering of informa-
tion. Motor amps are be measured in real time which allows precise calculation of battery
amps.
Secure Connection to AMP FASTON™ Tabs
Power Motor and Battery connections are made via standard 250mils (6.35mm) AMP
FASTON Tabs. FASTON connectors provide a high current and very secure connection,
proven over decades of use in the automotive industry. For maximum current handling,
use connectors for AWG10 wires recognizable by their yellow plastic insulator.
FASTON connectors have an extremely tight fit and will not come off on their own. It is
recommended, nevertheless, that the wiring is made so that the cables are never pulling
the connector outward.
Frequent disconnects and reconnects will eventually loosen the connector’s grip on the
tab. If frequent disconnection is required, consider using Positive Lock connectors from
TE Connectivity or their equivalent. These connectors have a spring loaded tab latch pin
that will lock into the hole of the male tab.
Electrical Specifications
Absolute Maximum Values
The values in the table below should never be exceeded, permanent damage to the con-
troller may result.
TABLE 7.
Parameter Measure point Min Typ Max Units
Battery Leads Voltage Ground to VBat 63 Volts
Reverse Voltage on Battery Leads Ground to VBat -1 Volts
Power Control Voltage Ground to Pwr Control wire 63 Volts
Motor Leads Voltage Ground to U, V, W wires 63 (1) Volts
Digital Output Voltage Ground to Output pins 30 Volts
Analog and Digital Inputs Voltage Ground to any signal pin on
15-pin & Hall inputs
30 Volts
RS232 I/O pins Voltage External voltage applied to Rx
pins
30 (2) Volts
Case Temperature Case -40 85 ºC
Humidity Case 100 (3) %
Note 1: Maximum regeneration voltage in normal operation. Never inject a DC voltage from a battery or
other fixed source
Note 2: No voltage must be applied on Tx pin
Note 3: Non condensing
Electrical Specifications