Quick Start Guide

www.geolink.io

Quick Start Guide (1.4) OpenTracker 2.4 1

OpenTracker 2.4

Quick Start Guide

1. Insert the SIM Card

OpenTracker has one Micro SIM slot. Larger SIM cards can be cut into micro SIM format in any shop that sells SIM

Cards or Mobile phones.

1. Unlock slot

2. Open cover

3. Insert SIM

4. Close slot and lock it

For your convenience the SIM PIN should be deactivated.

If this is not an option, the SIM PIN has to be entered into the “tracker.h” and flashed into the Tracker.

Take note of the IMEI code printed on the modem label (you may also scan the QR code) because you

will need this number to register your device on the Geolink website.

2. Connect the antennas

Take the antenna cable ends, plug them one after another into the antenna

connector on the OpenTracker. Turn the antenna cable connector clockwise.

Ensure to connect the antennas tightly.

Make sure to plug the GPS/GLONASS antenna (here shown orange) into the

connector labeled GPS on the board and the GSM antenna (here shown in

blue) into the connector labeled GSM.

3. Connect MOLEX Cable

Ensure the latch on the connector is facing up as shown in the picture.

Push the connector until it clicks.

PAGE 1
www.geolink.io OpenTracker 2.4 Quick Start Guide 1. Insert the SIM Card OpenTracker has one Micro SIM slot. Larger SIM cards can be cut into micro SIM format in any shop that sells SIM Cards or Mobile phones. 1. Unlock slot 2. Open cover 3. Insert SIM 4. Close slot and lock it For your convenience the SIM PIN should be deactivated. If this is not an option, the SIM PIN has to be entered into the “tracker.h” and flashed into the Tracker.
PAGE 2
www.geolink.io 4. Connect Power source and ignition cable of your vehicle OpenTracker supports 12V/24V nominal power supplies (the full range is 8 – 32 Volts DC). Please connect first the battery negative (B–) terminal to pin 6 (black wire), then the positive (B+) terminal to pin 1 (red wire) through a 2A fuse, as in the picture below. OpenTracker is preconfigured to go to a low-power mode if the car engine is turned off.
PAGE 3
www.geolink.
PAGE 4
www.geolink.io 6. SMS Commands Summary of the SMS commands for the initial configuration. The unit will accept only one command at a time and send a reply on successful command execution (this may take a while).