Operation Manual

Consumable parts
1. Blade
2. Virtual wire
3. Pegs
1
Handle:
2
Bumper:
To change a new direction when it
bump obstacles.
3
Charging point
4
Emergency switch:
Press it at any time, the mower
turn off at once.
5
Charging terminal:
Connect with charger for recharge
directly.
6
Rain sensors:
Mower goes back to charging
station automatically when it rains.
7
Power light
8
Key switch:
on
off
99
10
Blade
11
Safety hence:
To keep off foot and hands
12
Handle
13
Blade shed
14
Tyre cover:
Take it out and change the wheel.
15
Virtual wire light
Red: broken wire/idle
Colorless: good wire connecting
16
Charging light
Red: charging
Green: fully charged or idle
17
Charge terminal
18
Virtual wire terminal
Connect the virtual wire randomly.
there is no positive and negative.
19
Charging sheet
20
Guide channel
21
Stakes hole
22
Charger
Used for directing the mower to
charging station or for recharge
directly.
23
Virtual wire / 100m
Used to mark mowing area and
create a virtual wall for the mower.
24
Stakes / 4pcs
Used for fix the charging station to
ground.
25
Blades
Two blades pre-installed on the
mower and two extra.
2. PRESENTATION
-P8--P7-
27
26
Pegs / 100pcs
Used for fix the virtual wire to the
ground around the lawn perimeter
and around obstacles.
Remote control
Omni-directional wheel
28
Key / 2pcs
29
Remote control battery
30
English user maual
2. PRESENTATION
2.2 Functions
- Lift sensor
There are lift sensors located on each omni-directional wheel. If the
mower was lifted 2cm from the ground in level way, it will stop working
within 2 seconds.
- Tilt sensor
There is tilt sensor installed on the mower too, when the mower was
tilted over 30 degree at any direction, it also will stop working within 2
seconds.
- Bump sensors
In front of the mower there equipped with bump sensors that will activate
when the mower strikes solid, fixed object when that object is at least
6.5cm in vertical height from the supporting surface of the mower. When
the bump sensor is activated, the mower will stop movement in that
direction and reverse itself away from the obstacle.
- Rain sensors
There are two rain sensors on top cover of mower. The mower will go back
to the charging station automatically when it's raining.
- Wireless controller
To control the operate of mower in manual pattern.
- Anti-theft function
The mower should be turned on by key. And it can’t start working without
a matched charging station.
- Virtual wire
The robot lawn mower can't operate without a virtual wire. (we suggest to
use 100m-300m of virtual wire). It leads the mower back to charging
station and the mower will take it as a wall when it is operating. It will gets
on the virtual wire until it meets charging sheet which located in front of
charging station, then it gets off virtual wire and starts cutting
- Cutting height selection
There are two choice, 3cm and 4cm.