Specifications

18
- Insert the conical part into the bell. With the
washer touching the tube seal , turn the bell in
the direction of the arrow (see above figure) to
lock the bell lug and tube lug together
moderately tightly.
Removing the bell from the tube
- Check that the machine is not plugged in.
-Turn the bell in the direction of arrow (see next
figure) to separate the bell lug from the tube
lug . Remove the bell.
- If jammed, turn the blades inside the bell in the
direction of arrow to disengage them from the
drive shaft.
2
F
E
1
F
E
D
C
Removing the blade
- To remove the blade safely, hold them with the tool
provided or an oven glove or a thick cloth.
- Using the removal tool, unscrew the drive
coupling.
- As soon as the drive coupling has been unscre-
wed, the blade can be removed for cleaning.
• WHISK FUNCTION (only for CMP Combi)
E
F
1
TURN TO
REMOVE BELL
TURN TO
DISENGAGE
BLADES
2
BLADE LOCKING
BLADES WITH WATERTIGHT SEALS
BELL
DRIVE COUPLING
BLADE REMOVAL
A
C
B
Attaching the whisk holder to the motor unit.
- Check that the machine is not plugged in.
- Align the flat side of the conical part of
the whisk holder with the catch on the inside
of the aluminium casing.
- Insert the whole of the conical part of the whisk
holder into the aluminium casing.
C
B
C
A
- Turn the whisk holder in the direction of the arrow
(see figure) until it is locked into place moderately
tightly.
Removing the casing
- Check that the machine is not plugged in.
- Turn the whisk holder in the opposite direction to
that used when attaching it.
- When it will go no further, remove the whisk
holder from the aluminium casing.
Fitting the whisks into the whisk holder
A
C
B
D
E
- Grasp the holder in one hand.
- With the other hand, take the first whisk and insert
the shaft into the bore B of the whisk holder
drive shaft. Make sure the drive lugs are
properly aligned with the notches.
D
A