Operating instructions

7
ENGLISH
Position the French fry
grid over the motor shaft
with the raised, bladed
grid facing the dischar-
ge (exit) chute.
Next put the appropriate slicing plate on the motor
shaft.
Rotate the plate until the
slot in the plate hub falls
over the motor shaft pin.
Continue to rotate one
full turn. If the cutting
plate scrubs the grid-do
not proceed-call your
authorized service
agency.
5) Slide the hinge
pin into the locations
provided at the back of
the motor base. Then,
lock the lead onto the
motor base with the
latch.
6) If you are
not using the hollo-
wing nut, be sure
the partition is in
place.
NB : Use the provided
wrench to tighten or
remove the hollowing nut.
3) Always have the
hollowing nut in place
when you are not using
the divider. Screw the
hollowing nut down
over the plate, and into
the motor shaft.
Good Bad
1) With the motor unit
facing you, use your
right hand to release the
latch used to lock the
attachment onto the
motor base.
2) Tilt the attachment back and remove the plate by
lifting it from underneath. It may be necessary to
turn the plate slightly counterclockwise to loosen it.
For dicing equipment, you are advised to pull out
the grid and plate assembly together. Then remove
the discharge plate using the two holes.
If the discharge plate is stuck, turn it slightly in the
counterclockwise direction.
3) Before assembling the dicing equipment, it is
advisable to clean the inside of the motor support /
chute thoroughly using a damp cloth or sponge,
especially the part onto which the grid is to rest.
Always use a properly cleaned grid.
Never process soft food after hard without cleaning
the grid.
4) Then fit the discharge plate, the chosen plate or
combination and continue as previously described.
5) Close the lead and fasten the latch before
operating.
CONTINUOUS FEED
ATTACHMENT
The continuous feed attachment features two feed
openings :
A wide feed opening for processing vegetables
such as cabbage and lettuce.
Use the partition provided
and only the feed chute
opposite the exit chute when
making French fries.
W ARNING
4) Position the lead
assembly on the motor
base. The latch is now
facing you on your
right.
CHANGING THE PLATES :
Wear cut resistant gloves when handling the
plates.
The machine should be switched off (by pressing
the red push-button) before changing plates.
The hollowing nut used only to
prepare cabbage. This tool can be
used to shred or grate a whole cabba-
ge without having to cut it beforehand.
A special tool has also been designed
to remove the hollowing nut.