Specifications

20

Slide the hinge pin
into the slots provided at
the back of the motor
base.
Next, lock the lid onto
the motor unit using the
locking handle.
TO CHANGE THE DISC:
1) With the motor unit
facing you, release the
aluminium locking
handle used to lock the
veg prep head onto the
motor unit with your right
hand.
Lift the vegetable preparation head, tilting it back to
release the bowl.
2) Remove the disc by lifting it from underneath using
the hub and if necessary, tur n in an anti-clockwise
direction to release…
If you have been using a dicing unit, we recommend
you remove the grid and the disc at the same time.
This will be easier if you first rotate the emptying disc
and pull it out by the two holes.
3) When fitting dicing equipment, we recommend
that you clean the inside of the bowl with a sponge,
particularly the par t onto which the grid is to be
fitted.
Always use a properly cleaned grid.
Never process soft foodstuffs after hard ones
without properly cleaning the grid beforehand.
Use our D-Clean Kit (ref. 39881) to clean your
5x5, 8x8 and 10x10 dicing grids quickly and
easily
4) Fit the discharge plate, disc or dicing equipment
as indicated in “assembly procedures” in points

and

.
5) Close the veg prep lid and lock it onto the motor
unit with the locking handle.
HOPPER USE AND
DISC CHOICE
The lid of the vegetable processor features two feed
openings:
- One large hopper for cutting vegetables such as
cabbage, celeriac, etc... This hopper can be
partitioned with a divider. This makes it easier to
deal with round or oval vegetables.
- One cylindrical hopper for long vegetables and
high-precision cutting. Cutting quality can be
optimized if the compartment is used as a cutting
guide.
- Raise the pusher to gain access to the feed
opening.
Please use the spanner supplied with the
appliance to remove the cabbage corer.
No tools (loading cone or cabbage corer) are requi-
red when using the divider.

Slip the hinge pin into
the locations provided at
the back of the motor
base.
The locking handle should
now be facing you, on the
right.
Loading cone Cabbage corer
Next fit the appropriate
slicing disc and rotate in
a clockwise direction to
check that it i correctly
positioned.

Then, screw the loading cone or the hollowing
cutter onto the motor shaft according to the type of
vegetable to be prepared (unless using the remo-
vable divider).
It should be remembered that the loading cone is
suitable for all types of vegetable except for cabbage.
The hollowing cutter is designed for that purpose.