Specifications

22
The CL 52 is equipped with a magnetic safety
system which stops the motor as soon as either the
wide feeder or the lid is opened.
This makes it impossible to gain access to the slicing
tool while it is still in motion.
As soon as the lid opens, the motor stops.
SAFETY
WARNING
• WORKING HEIGHT
We recommend that you position the CL 52 on
a stable worktop so that the upper edge of the
large feed hopper is at a height of between1.20 and
1.30 m.
• NOISE LEVEL
The equivalent continuous sound level when
the CL 52 is operating on no-load is less than
70 dB(A).
Three-phase machine
- Power shown on data plate.
TECHNICAL SPECIFICATIONS
• WEIGHT
Net Gross
CL 52
E complete 25.5 kg 28 kg
Average weight
of one disc
0,5 kg 0,6 kg
• DIMENSIONS (in mm)
A 690
B 340
C 360
Motor
Speed
(rpm)
Intensity
(Amp)
230 V/50Hz 375 5.3
240 V/50Hz 375 5.3
120 V/60Hz 450 8.9
220 V/60Hz 450 5.3
Motor
Speed
(rpm)
Intensity
(Amp)
400 V/50Hz 375 2.0
220 V/60Hz 450 4.4
380 V/60Hz 450 2.6
• ELECTRICAL DATA
Single-phase machine
MAINTENANCE
• MOTOR SEAL
The motor seal on the shaft should be lubricated
regularly using a food safe lubricant.
In order to keep the motor completely watertight, it
is advisable to check the motor seal regularly for
wear and tear and replace if necessary.
The motor seal can be easily replaced without
having to remove the motor, so we strongly advise
you to ensure that is in good condition.
• BLADES AND PLATES
The blades on all our discs are wearing parts that
need to be replaced from time to time, in order to
maintain consistently high cutting quality.
• GRATING DISCS
Grating discs deteriorate over time. We recommend
you replace them from time to time, in order to
maintain consistently high cutting quality
The discs are very sharp, handle with care.