User Manual

Basic Operation
RoboSHOOT
©
User’s Manual Page 25
Profile Bracketing
Profiles Bracketing (MX-20 only) takes four
exposures sequentially, one for each profile. To use
profile bracketing, a shutter release cable must be
connected between RoboSHOOT
©
and your Camera.
The camera shutter release button is configured by
default to start the bracketing sequence.
Profile Bracketing is engaged by a full push-and-hold
of the top button until the LEDs strobe (see page 11).
The Main Yellow LED will periodically pulse three
times indicating this mode is active.
Exit Bracketing by clicking the side button or turning
the camera off/on.
Button Lockout
If the Main LED flashes red every time a button is
pressed, the buttons are locked out. This mode
allows you to prevent unwanted button operations.
Lockout mode is toggled by a 5 second push-and-
hold on the top button (fully pressed) and side
button at the same time. The main LEDs will blink
red when lockout is engaged and green when it is
disengaged.
MX-20