User Manual

Basic Operation
RoboSHOOT
©
User’s Manual Page 13
Getting Started
Connecting the modules
Note: Be sure all batteries are fresh!
Alignment
Pin
Extends when
knob is tight
1) Attach MX-15 or MX20
Master to Camera.
2) Attach Speedlights to
RoboSHOOT
©
Flash Shoe.
Make sure alignment pin
is engaged if present.
3) Turn on RoboSHOOT
©
devices.
4) Turn on Speedlights.
5) Turn on Camera.
Turning on the camera
activates and synchs
RoboSHOOT
©
devices and
wakes the speedlights.
Should a speedlight not
support wake up, you
may need to cycle power
on that speedlight.
Must engage
with this
alignment hole
Retractor Pin
shows when
aligned
Camera
MX-15 or MX-20
MX-15 or MX-20
MX-15 or MX-20
IMPORTANT: Secure the Master on Camera Tightly and ensure
ALIGNMENT PIN IS ENGAGED WITH ALIGNMENT HOLE. Make
sure all modules and speedlights are tightly secured with
Alignment Pin engaged, if present. Failure to do so may result in
intermittent operation and/or drop damage.
Always turn off a speedlight when attaching or detaching
it!