User Manual

Basic Operation
RoboSHOOT
+
©
User Manual Page 27
Profile Bracketing
Profiles Bracketing (MX-20
+
only) takes four
exposures sequentially, one for each profile. To use
profile bracketing, a shutter release cable must be
connected between RoboSHOOT© and your
Camera. The camera shutter release button is
configured by default to start the bracketing
sequence.
Profile Bracketing is engaged by a full push-and-hold
of the top button twice until the LEDs strobe. The
Main Yellow LED will periodically pulse three times
indicating this mode is active.
Exit Bracketing by clicking the side button or turning
the camera off/on.
Mult-Angle Photography
MX-20
+
/ RX-20 can be configured for remote release
of additional cameras. This enables simultaneous
exposures from different camera angles via the App
or external trigger. See Device Admin for details and
to configure the RX-20 for this purpose.
MX-20
+
Note, by default, holding the Top button toggles
between Profile Select, Profile Bracketing (MX-
20
+
only), and none. This can be configured via
the App.