User Manual

Basic Operation
RoboSHOOT
+
©
User Manual Page 25
Selecting a Profile
With profiles, you can quickly set all group levels, the
Master Offset, Zoom, and Angle to previously
defined values. Briefly, a profile is just a snapshot of
values used to setup the flashes. RoboSHOOT has
space for four profile snapshots. This is useful, for
example, to:
 Quickly Access a set of favorite values
 Provide repeatability – for example, when
taking several shots of multiple subjects,
you can quickly apply the same settings to
each subject.
 Experiment with uncertain lighting very
quickly, for example with Macros. In this
case, RoboSHOOT can bracket across the
four profiles automatically. (MX-20
+
)
Profile selection is performed by holding the top
button to enter select mode and clicking the same
button to select the desired profile. While in profile
Select Mode, the main Red LED is blinking a slow
dash-dot pattern and the Green Group LEDs indicate
which profile is active (A is profile 1, D is profile 4).
The group Red LED brightness indicates the relative
power levels of the current profile. Profile Select
mode exists after about 10 seconds of inactivity.