User Manual

Basic Operation
RoboSHOOT
+
©
User Manual Page 23
Flash Test / Modeling Light
To Test fire each TTL speedlight ½ click (½ hold on
MX-15
+
) the top button to perform a Flash Test. On
the MX-20
+
you ½ hold the button to briefly activate
the Modeling Light if your compatible flash is so
equipped. (see page 11).
Top Button configuration for the MX-20
+
can be
changed via Flash Group Settings while connected
to the unit. The unit will respond according to last
programmed settings.
Enabling or Disabling Flashes quickly
Push-and-hold the side button to enable/disable
flash (see page 11). The Main LEDs will strobe when
the command is accepted and the Group LEDs will
indicate current status. To re-enable the flashes, just
repeat the push-and-hold or click the button to
clear. Turning on the camera or engaging another
device function will also re-enable all groups.