User Manual

Basic Operation
RoboSHOOT
+
©
User Manual Page 15
Speedlight Settings
To utilize TTL be sure to use Speedlights fully TTL
compatible with RoboSHOOT
©
. These should be set
to TTL mode normally with compensation set to
+/- 0. In addition, set Zoom to Auto if you want the
camera or App to control zoom. For supported
manual or supported TTL-incompatible speedlights
set the speedlight to manual.
Consult www.sereneautomation.com for current
information about compatible speedlights.
Unsupported speedlights should not be used.
Speedlights with unknown support status may or
may not operate even in manual mode. Worse,
damage to the speedlight or RoboSHOOT
©
device
could occur. For any speedlight with unknown
support status, always use manual mode and ensure
voltages on the shoe do not exceed 6V. If in doubt,
do not attempt to try a speedlight that is not
officially supported.