User Manual

Basic Operation
RoboSHOOT
+
©
User Manual Page 13
Getting Started
Connecting the modules
Note: Be sure all batteries are fresh!
Alignment
Pin
Extends when
knob is tight
1) Attach MX-15 or MX-20
Master to Camera.
2) Attach Speedlights to
RoboSHOOT
©
Flash Shoe.
Make sure alignment pin
is engaged if present.
3) Turn on RoboSHOOT
©
devices.
4) Turn on Speedlights.
5) Turn on Camera.
Turning on the camera
activates and synchs
RoboSHOOT
©
devices and
wakes the speedlights.
Should a speedlight not
support wake up, you
may need to cycle power
on that speedlight.
Must engage
with this
alignment hole
Retractor Pin
shows when
aligned
Camera
MX-15 or MX-20
MX-15 or MX-20
MX-15 or MX-20
IMPORTANT: To ensure proper operation and minimize drop risk
check that alignment pin is mated and engage locking mechanism
on all RoboSHOOT
©
units and speedlights. Always turn off the
speedlight when attaching or detaching it!
NOTE: Each time you turn on the camera the units will resync for
a few seconds. Thus if you power on a remote unit after the
master unit, it will be recognized by recycling the camera power.