Use and Care Manual
21
1. Adjust ow rate
3. Install the mop cloth
4. Install the module
2. Fill the water tank
Toggle the switch to adjust the ow rate according to your
needs.
Dampen the mop cloth and squeeze it until it stops dripping.
Insert it into the mounting slot in the water tank.
Slide the mop module in line with the alignment marks on the
rear of the machine until you hear a "click".
Open the water tank, ll it with water, and close it tightly.
Installation
Mopping
5
Note:
•
It is recommended that all oors are vacuumed at least three times before the rst
mopping session to reduce excessive dirt buildup on the mop.
•
Use barrier tape to prevent mopping carpeted areas, or remove carpets prior to
mopping.
•
To prevent corrosion or damage, do not use cleaning uid or disinfectant in the water
tank.
•
Cleaning the mop cloth every 60 minutes is recommended to ensure the water ow
rate and cleaning eect.
Low
High