Installation Guide

Roboreel
®
Ceiling Mount Air Hose Reel 1-888-GR8-STUFF
Quick Start Guide – Page www.roboreel.com
This Quick Start Guide does not replace the User Guide. For complete details and precautions concerning this product, read all instructions in the User Guide provided
CAUTION: The Air Hose System is rated for dry, indoor use only.
DO NOT OPERATE IN WET ENVIRONMENT
IF YOU HAVE ANY QUESTIONS OR DIFFICULTIES CALL OUR CUSTOMER SUPPORT TEAM: 1-888-GR8-STUFF
1. Mount / Ball Stop Installation
1. Install Ceiling Bracket to ceiling. (Figure 1a)
2. Position the unit’s swivel bracket (1) at the opening of
the installed ceiling bracket, and pull the spring-loaded
safety pin (2) on the ceiling bracket outward to allow
the unit to slide in until reaching the travel stop.
(Figure 1a ,1b)
1. Release the spring-loaded safety pin – it will now lock
into place. Confirm by inability to slide the unit out.
2. With unit’s swivel bracket against the travel stop,
tighten the Locking Screw. (Figure 1a)
3. Install the Ball Stop onto the hose using four (4)
screws (provided). The Ball Stop should be positioned
on the hose so that the hose end is within reach when
hose is fully retracted. (Figure 1c)
Reel Parts Diagram
1
Doc. No. 070-000140-01, Rev 1
Travel
Stop
Figure 1b
Figure 1a
Ball Stop
Figure 1c
WARNING: The unit must be installed on a structure which is
capable of supporting the weight of the unit. Mounting the unit
onto structures incapable of supporting the weight of the unit may
cause it to detach, resulting in injury or death.