Product Manual
Chapter 10-5
Maintenance and Storage
Storing the Perimeter Switch10.9.3
Disconnect the Perime e Switch, remove the batteries and store it in ❍
a dry place.
Storing the Base Station10.9.4
It is recommended to remove the Base Station for the winter:
Disconnect the power supply from the power receptacle. ❍
Disconnect the 15m extension cord from the Base Station Board. ❍
Remove the extension cord and place it in dry place. ❍
If it is not practical to remove the extension cord (15m cabl ): disconnect if from
the boa d and protect t for the win er to prevent oxidation.
Unscrew the two screws holding the Base Station Cove . ❍
Disconnect the green plot connector (between the perimeter wire and ❍
the Charging board)
Disconnect the green plot connector and place a water proof wire ❍
connector over the two free perimeter wire ends.
This prevents wire corrosion while not connected to the station.
Store all other parts in a dry place. ❍
Getting ready for the new season ❍
Before the new mowing season starts, lightly polish the )
charge contacts on the Robomow and the Base Station
with a small piece of fine sandpaper, 200 grit or higher or
with steel wool of ‘00’ or higher grade.
This will remove any oxidation and allows optimal contact.
Before the first operation of the new season, reconnect )
Base Station setup (see chapter 2).