Product Manual

Chapter 4-3
The mowing process – automatic and manual operation
Activating the Perimeter Switch 4.5
(Non base-station zone)
c Important! c Mowing in non-Base Station zone requires a prior
setting of each such zones.
If the zone to be mowed is not defined yet, do the setting now .
In order for Robomow to operate in a non base-station zone: the Perimeter
Switch has to be turned on and the mower should be inside the active
perimeter area.
Verify that a Perimeter Switch is connected to the zone to be mowed. ❍
Press the ❍ P ‘ON’ button to turn on the Perimeter Switch.
A short beep sounds when the Perimeter Switch is turned on.
A green LED flashes to indicate proper operational state.
If one of the red LED indicators flashes, there may be some )
malfunction.
For more details, please refer to the troubleshooting guide (Chapter 8).
A “No Wire Signal” message on the Robomow’s Display is )
an indication that Perimeter Switch is not turned on.
Verify that you have properly connected the Switch to the
Perimeter Wire, using the small green connector.
Positioning Robomow on the lawn. 4.6
Serious injury or death hazard!
This machine has sharp rotating blades.
When operating in automatic mode, keep children, pets and
bystanders away from mower. Do not leave mower unattended
while operating .
Never allow people or pets to ride on mower or block its path of
movement.
Drive Robomow into the lawn area. ❍
Remove the Manual Controller from its holder. )
Use the Navigator Button to drive Robomow. )
Use the speed button to toggle between )
fast and slow
speeds.
Position Robomow at least 1 m (3 ft) from the Perimeter Wire. ❍


  


         
 