Product Manual
Chapter 3-2
Robomow RL555, RL855, RL2000
If the grass is extremely high ❍ , adjust the height and ground clearance
of Robomow to their highest position.
Reinsert Manual Controller in its holder. ❍
Adjust the controller and its coil until it is at level with top of Robomow.
In Base zone - confirm the Base Station is connected to the power. ❍
In Non Base zone, press the P ON button on the Perimeter Switch to
activate the Perimeter Wire.
Press Robomow’s ❍
button and go
through the following steps:
If during the calibration process, a message is ❍
displayed when pressing the
button,
refer to the troubleshooting table of this manual
(Chapter 10).
Such messages may be: “Check Signal”, “Start
Inside” or “No Wire signal”
Robomow will circle slowly throughout the
calibration process.
Be patient until calibration is complete, it usually
takes a few minutes.
For the duration of the process the display panel
flashes a “wait” message.
Rarely, the first attempt to calibrate may fail. In
such rare cases a “retry elsewhere” message is
displayed. This usually is a result of interference
such as nearby metal objects or even
underground wires.
If a “retry elsewhere” ❍ message is displayed,
move Robomow to another flat spot, at least 3
meters (10 feet) away and recalibrate.
Once the process is successful, no further
interference can effect Robomow’s calibration.