Use and Care Manual

Lay it loosely along the perimeter as you walk along the lawn

edge. If you get to any area/object that needs special care,

make sure you carefully lay the Perimeter Wire as described in

the following sections.

Start unwinding the wire counter-clockwise around the lawn,

starting at the Base Station’s location.

Peg

Once a tail is made, put the

ﬁrst peg into the ground to

secure the end of the wire

Perimeter

Wire

A. Make a Good Start

Before you begin, walk along the edge

of your lawn and plan how to set up the

Perimeter Wire. Take

note of all obstacles

and slopes.

Pull out approx. 30 cm (1 ft) of wire through the hole in the

spool’s plastic covering and peg the beginning of the wire to the

ground where you intend to install your Base Station.