Installation Guide

83
Message
Displayed
Probable Cause /
Event
Corrective Action
Cross Outside
The Perimeter Wire is too
close to the edge.
Move the wire towards the inner side
of the lawn.
The lawn slope near the edge
is too steep and causes the
mower to slip outside.
Do not include areas with very steep
slopes near the perimeter wire.
The lawn’s edge is too
bumpy.
Fill holes and pits along the edge
untill level with the ground.
Stuck In Place
The mower got stuck in
place. It cannot continue
driving.
Check the ground for holes or
indentations. Fill it with soil.
Check if the Perimeter Wire is not
too close to the edge. Move the wire
towards the inner side of the lawn.
Check Mow
Height
Mowing system is in overload
due to very tall grass or an
obstacle that is stuck or
wrapped around the blades.
Turn o the mower, remove the
Disabling device and inspect the
blades. Remove any foreign object
or excessive clogging inside the
mowing deck.
Raise the mowing height.
Check Power
There is a temporary power
cut.
Conrm that the Power Supply unit
is plugged in to mains.
The Power Supply unit is not
plugged in properly.
Conrm the Power Supply is
properly connected to the extension
cable, and the cable is connected to
the Base Station.
There is no charging source
detected.
Clean the charging contacts on
the Base Station and verify proper
connection of the Base Station to the
Power Supply unit.
No Wire Signal
/ Waiting for
Signal
Power Supply unit is
unplugged or there is a
temporary power cut.
Make sure the Base Station is
connected to the mains supply.
Signal generator may need to
be restarted.
Disconnect the Power Supply from
the mains supply and reconnect after
10 seconds.
The Perimeter Wire is not
connected to the Base
Station.
Check the connection of the
Perimeter Wire to the Base Station.
The Perimeter Wire is cut. Check for cuts in the Perimeter Wire.
Troubleshooting
7