Use and Care Manual

48 49
TIPS
(Not applicable to models for lawns under 800 m
2
/ 8600 ft
2
)
• When the mower completes its operation, it drives to the
Base Station at a dynamic offset from the Perimeter Wire
(“Near Wire Follow” mode). This is in order to prevent wheel
tracks along the same path.
• After completing the Wire Position Test, it is recommended
to test the mower in Near Wire Follow mode to make sure it
works smoothly.
• Press ‘Settings’ for more than 3 seconds and use menu
P006 to initiate the test.
• If the mower fails to complete the Near Wire Follow test
smoothly, reduce the maximal allowed offset from the wire
using menu P004