Operation Manual

13
EN
There are two options to set the Base Station:
3.2.2 Internal Setup (on the lawn perimeter)
Choose a place along the Perimeter Wire where
you want to place the Base Station, based on the
inputs given in paragraph 3.2.1.
Place the Base Station in the direction shown in
the gure to the right.
3.2.3 External Setup (off the lawn perimeter):
There are two types of External Setup:
A. At a corner
In this type of setup, the Base Station is located at one
of the corners of the lawn, as shown in the gure at
the right.
Choose a corner where you want to place the Base
Station outside of the lawn area.
Place the Base Station, where its front side is touching
the lawn edge or placed somewhat on the lawn.
Continue to lay the perimeter wire as shown in the
gure to the right, where it continues at least 10cm
(4”) beyond the Base Station and turns back towards
the lawn at a distance of 10cm (4”) from the other
wire.
The Base Station may be placed in a small shift to the
right in order to allow smooth entry of the mower to
the Base Station.
You will have the opportunity to later adjust the Base
Station position to conrm smooth entry.
B. Outside the lawn
(Can be set only through the Robomow App for
specic models)
• Choose a place outside the lawn where you want
Robomow to dock and charge.
• Conrm the path between the lawn and the outside
area is smooth with no height difference, so
Robomow will not get stuck and will follow the wire
smoothly.
• The surface between the lawn and the Base Station
should be hard (such as a sidewalk or rigid ground)
and not sandy or stony, so Robomow will not slip or
get stuck on it.
• The area between the lawn and the Base Station
should be clear of obstacles and objects.
• Lay the wire as shown in the gure to the right:
- Narrow path of 50cm (20”) width.
- Square Perimeter Island of 30cm (12”) edges.
- Island starts 50cm from the Perimeter Wire.
- Keep a distance of 10cm (4”) between Perimeter
Wire and the Island from both sides.
- The front of the Base Station should be placed a
minimum distance of 1.5m (5 ft.) from the Perimeter
Wire and NOT more than 4m (13 ft.).
10cm (4”)
Min. 10cm (4”)
Main Zone
10cm (4”)
Min. 1.5m (5ft) – Max 4m (13ft)
Perimeter Island
30 cm
10cm (4”)
50 cm (20”)
50 cm (20”)