Operation Manual

12
Types of Separated Zone setups:
A Separated Zone smaller than 100 m² (1100 ft²)
o Separated area that is smaller
than 100m² (1100 ft²) can be
covered in a single operation,
thus, if possible, the separated
area may be connected to the
main area’s Perimeter Wire
(have the signal come from the
Main Base Station).
Or
o It may need its own separate
Perimeter Wire.
In that case, it will have to
be connected to a Perimeter
Switch (optional accessory –
see Chapter 12 – Accessories).
Or:
A Separated Zone larger than 100 m² (1100 ft²)
o If a separated area is larger than
100m² (1100 ft²), then it requires
more than a single operation to
cover the area;
o In such cases, an additional
Base Station (optional accessory)
should be installed in the
Separated Zone; otherwise
you will have to manually bring
the mower several times to the
Separated Zone in order to
complete the mowing of the area.
3.2 Select Base Staon Locaon
3.2.1 Base Station Location Guidelines
Do not place the Base Station within 3 meters (10
ft.) after a corner (relevant for Internal Setup only
– section 3.2.2)
The Base Station should be within 15m (50 ft.) of a
power outlet (230V / 120V).
If the lawn has more than one zone, place the Base
Station within the largest zone.
Make the Base Station invisible to the street to
avoid theft.
Select a shady spot. This will extend battery lifetime.
Place the Base Station on a relatively level ground.
Do not place it on a slope.
Place the Base Station away from sprinkler heads.
Separated Zone Smaller than 100m² (1100ft²)
2 Wires under
same peg
Base Station
Separated Zone larger than 100m² (1100ft²)
Optional Power Box &
Base Station
Main zone Power Box &
Base Station
Min. 3m (10ft) from any
corner