User manual

• Press this button again to enter Standby Mode.
How to use the Remote Control:
The Power Button “ ”
• When the Robomaid RM-770 is switched on, press the Power Button for the cleaner enter Sleep
Mode, which will save power and all indicators will be o.
• When the cleaner enters Sleep Mode, it can not be started by pressing any button on either
the cover or the remote control.
AUTO Button:
Press this button and the Robomaid RM-770 will work in an automatic cleaning mode until the battery
power is used and then will automatically search for the Docking Station for recharging.
SPOT Button
DOCKING Button
Wall-Following Button “ ”
Speed Adjuster “ ”
Pause button “ ”
UV Button “ ”
Directional Buttons (Forward, Backward, Left, Right):
Press the arrow buttons to control the Robomaid RM-770 to move in the designated direction.
Right
Forward
Left
Backward
Do not press more than one button on the remote control at any one time as the Robomaid
needs clear, slow commands.
The eective distance of the Remote Control is 5-7 meters.
Press this button for the Robomaid RM-770 to start cleaning in the
indicated mode and once nished will not go into Docking Mode. (See Page 6)
Press this button for the Robomaid RM-770 to start searching for the
Docking Station.
Activates cleaning in the wall-hugging mode and once nished will not
go into Docking Mode. (See Page 7).
Switches the UV lamp on and o.
Changes between 3 dierent speeds of operation. The default speed
is the fastest.
Stops the Robomaid and enters Standby Mode.
This makes the RM-770 clean forwards and it will automatically
stop when it meets an obstacle.
This makes the RM-770 move backwards for approx. 30cm.
This makes the RM-770 turn Left 10 degrees and then clean forward.
Holding the button down increases the angle of the turn.
This makes the RM-770 turn Right 10 degrees and then clean forward.
Holding the button down increases the angle of the turn.
Installing or Replacing Batteries for the Remote Control
• Please note batteries for the Remote Control are not included and need to be purchased separately.
It requires 2 x AAA size batteries.
• Slide open the battery cover on the Remote Control and remove batteries if needed.
• Insert two batteries. Please ensure the batteries are in the correct direction as shown below, otherwise
damage may be caused.
• If the Remote Control will not be used for a long amount of time, it is best to remove the batteries.
7