User manual

Charging Mode

Please take care when plugging in

Power Adaptor!

2 erugiF 1 erugiF

4 erugiF 3 erugiF

1. Take out the battery before disposing of the product.

2. Always remember to cut o the power before removing the battery.

3. Recycle or dispose of the battery properly.

4. Do not throw battery into re!

5. If the battery is leaking, do not touch any leakage. Use a dry cloth

and dispose of the battery.

6. Do not impact battery or drop from a high place.

Please take care when plugging in

Power Adaptor!

A full charge takes about 3-5 hours, for the rst 3 times after purchasing the RM-770, please ensure

it is charged for at least 12 hours each time to build battery capacity.

Please try to fully use the battery power before charging for the rst 3 times.

Removing / Replacing the Battery

• You can directly charge the cleaner with the Power Adapter or with the Docking Station. (See Figure 2)

• To charge directly via the power adaptor, connect the power adaptor to the charging socket on the RM-770. (See Figure 1)

• When charging with the Docking Station, the Robomaid must be switched ON.

• When charging with the Power Adaptor, the Robomaid can be switched ON or OFF, however it can not be activated until

the power adaptor has been disconnected.

• During the charging process, the TIME icon will show on the display and the battery level bars will ash to indicate

charging. (See Figure 3)

• Upon completion of the charging, the display will show 3 full red bars and the TIME icon will disappear. (See Figure 4)

• During the charging, the display will show the amount of charging time where the number shown times 10 equals the

actual number of charging in minutes.

• When the Robomaid is not being used, it is best to keep it in Charging Mode, either on the Docking Station or connected

to the Power Adaptor.

• The Robomaid will enter Standby Mode if the power supply is cut o during the charging process and the

Robomaid is switched ON.

• Open the battery cover with a phillips head screwdriver and disconnect the battery as shown below.

• When connecting a new battery, ensure the red and black connectors match up, otherwise damage may be caused.

• The battery model number is: YX-Li-022148