User manual

Standby Mode

Docking Mode

If the Robomaid runs completely empty, it may not charge from the Docking Station and must be charged by

the Power Adaptor connected directly to the Robomaid.

Figure 1 - Docking Mode

• Switching the power switch to ON (see the gure below) switches the Robomaid ON and into Standby Mode.

• In Standby Mode, the current mode will be displayed (the default is “AUTO 1” ).

• If the Robomaid is left in Standby Mode for more than 3-5 minutes, it will start chirping every 30 seconds until the

Robomaid is activated, switched OFF, or recharging.

• To turn the RM-770 o, just switch the power switch to the OFF position.

• While the RM-770 is switched OFF, the remote control, timer, or control panel will not work.

• In Docking Mode, the Robomaid RM-770 will automatically begin to search for the Docking Station to recharge when

the battery level is lower than 15%.

• When the Robomaid is in Docking Mode, the display will show the three red battery bars (see Figure 1) and the sound

of the Robomaid will be almost silent as the brushes and vacuum do not work in Docking Mode.

• Activating DOCKING mode on the Control Panel of the Robomaid RM-770 or on the Remote Control, will manually

activate the search for the Docking Station to recharge.

• While the Robomaid RM-770 searches for the Docking Station, pressing any other button on Control Panel or

Remote Control will stop the RM-770 searching and enter Standby Mode. The directional buttons on the Remote

Control can also be used to manually assist the searching function.

• The Robomaid will search for the Docking Station and once within range of the Docking Station signal will attempt to

line up and dock. The Robomaid may turn away from the Docking Station and move about 2-3 meters away from the

Docking Station before turning back in line and docking.

• If the docking is not successful and the recharging does not begin, the Robomaid will reverse o the Docking Station and

attempt to dock again. The Robomaid can also be picked up and placed on the Docking Station physically if needed.

• If the Robomaid cannot nd the Docking Station and the battery power becomes lower than 8% of the capacity, it will stop

searching and stop in a clear and bright place, and will chirp every 30 seconds until the battery is completely at. It will then

need to be charged by plugging in the Power Adaptor directly in the Robomaid.

• Once the Robomaid docks successfully, it will go into Charging Mode.