User manual

Technical Specications
Model
Dimensions
Weight
Speed
Charging Time
Operation Time
Noise Grade
Input
Rated Power
Made in China
Robomaid RM-770
Diameter: 35cm Height: 11cm
3.5kg
24cm/Sec (fastest) 15 cm/sec (slowest speed)
3 - 5hrs
45 - 60 mins vacuuming plus up to 60 mins docking
~65dB
24V — 1A
45W
Country of Origin
Capacity of dustbin
1000CC
Length of Main Brush
25cm
Battery
14.4v Lithium-ion
Troubleshooting (cont.)
Robomaid keeps getting stuck
• Check the error code and refer to the table on the previous page.
• The Robomaid is about 11cm high, but can get stuck on furniture that has a gap of between 10-11cm. If this is the case,
try sectioning the area o with a Virtual Wall or if possible, increase the height of the furniture by 1cm.
• If the Robomaid is getting stuck on carpet, check that the mopping attachment is removed.
• The Robomaid can get stuck on any long strands of carpet, fringes of rugs, cables, shoelaces etc, so ensure the area
is tidy and free from any obstacles that it may get stuck on.
• If there is a situation that the Robomaid gets wedged, the sensors may not detect this. Use a Virtual Wall to avoid these areas.
Docking Station display goes out
• The docking station display can cut out if moved frequently.
• Reset the display by unplugging the Docking Station and leaving it oine for about 48 hours. In the meantime, charge
the Robomaid directly with the Power Adaptor. The display of the Docking Station should come back and remain xed.
The Dustbin won’t come out
• The dustbin does t tight in the cleaner to create a better seal for the vacuuming. If the dustbin is dicult to open,
use one hand and push the top of the silver button with your thumb and at the same time, use your ngers underneath
the dustbin to slide it out if needed. Pushing down on the front of the Robomaid while pressing the button also helps.
Virtual Wall won’t switch on
• Ensure the batteries are installed correctly. See page 9 for a diagram.
• When switching the Virtual Wall on, hold the ON/OFF button down for a few seconds until the green light starts ashing.
General Hints
• Remember to keep the Robomaid clean and be sure to regularly clean the main brush
to keep it free of excessive hair.
• Keep the Docking Station in a clear area away from wireless devices with plenty of room
on either side and in front of it to allow the Robomaid to dock correctly.
• Be sure to charge the Robomaid for at least 12 hours for the rst few times of use.
• Be sure to keep the area tidy from objects and obstacles that the Robomaid can get stuck on.
The Dustbin keeps coming out
• Check that the lters in the dustbin are installed correctly. Check the latch on the top of the dustbin is operating correctly.
Robomaid suddenly became extremely noisy.
• URGENT! The main brush must be revomed and cleaned thoroughly - especially the ends of the brush - to prevent damage.
The Robomaid Doesn’t Detect Stairs or Ledges
• The Robomaid will detect stairs that are 10cm or higher.
• If the top step or ledge is rounded, the Robomaid may have trouble reversing away from it. Use a Virtual Wall.
• If the oors are especially shiny, the oors may reect the sensors and the Robomaid may not detect the step.
• Always supervise the Robomaid when using it near a stair case. Never put the docking station or any object that will cause
the Robomaid to reverse near the top of the stairs or near a ledge.
• Use the Virtual Wall across the top of the stairs if needed.
14