User manual

How to Use The Virtual Wall

Before using the Virtual Wall, install the batteries as shown in Figure 3, open the bottom cover of the

Virtual Wall, install 2 x D batteries. After the installation, close the bottom cover and tighten the screws.

Make sure you put the batteries in the correct way.

Select the distance selector of the Virtual Wall according to the actual requirements. Slide the

switch to the top position to select the lowest level (0-4m), to the middle to select the middle level (4-7m)

and to the bottom to select the highest level (above 7m) See gure 2. The lowest level uses the least

amount of power.

Press and hold the power button on the Virtual Wall and the indicator will start ashing. If the batteries

are low in power, the indicator will ash faster and the batteries should be replaced.

The Virtual Wall sends an infrared signal with a 15° degree range.

The Virtual Wall uses 2x D (1.5V) batteries. When the batteries are running low, it is recommended

to replace them as continued use with low power may damage the Virtual Wall.

The Virtual Wall sends a special infrared signal to prevent the Robomaid RM-770 from entering

unnecessary or unwanted areas or to reduce the cleaning area.

01.

02.

03.

04.

05.

Distance selector

Infrared signal emitter

Wall signal emitter

Indicator

Power switch

Rubber pad

Bottom cover

0-4m

4-7m

Over 7m

Figure 1

Figure 2 Figure 3

Figure 4

You need to use a screwdriver to open

the bottom cover of the Virtual Wall. (see Figure 3)

See Figure 4 for the installation of batteries. Make

sure to insert the batteries in the correct way.

Ensure no obstacle is placed in front of the

Virtual Wall when in use.

Installing and Replacing the Batteries