Users Manual

• description: Weighting of red or blue to green color channel. This feature is only available on color
sensors (wb_ratio, Section 6.1.3).
Category: DigitalIOControl
Note: If IOControl license is not available, then the outputs will be configured according to the factory defaults
and cannot be changed. The inputs will always return the logic value false, regardless of the signals on the
physical inputs.
LineSelector
• type: Enumeration, one of Out1, Out2, In1 or In2
• default: Out1
• description: Selects the input or output line for getting the current status or setting the source.
LineStatus (read-only)
• type: Boolean
• description: Current status of the line selected by LineSelector.
LineStatusAll (read-only)
• type: Integer
• description: Current status of GPIO inputs and outputs represented in the lowest four bits.
Table 8.1.1: Meaning of bits of LineStatusAll field.
Bit 4 3 2 1
GPIO In 2 In 1 Out 2 Out 1
LineSource (read-only if IOControl component is not licensed)
• type: Enumeration, one of ExposureActive, ExposureAlternateActive, Low or High
• default: ExposureActive for Out1 and Low for Out2
• description: Mode for output line selected by LineSelector as described in the IOControl module
(out1_mode and out2_mode, Section 7.2.1). See also parameter AcquisitionAlternateFilter for
filtering images in ExposureAlternateActive mode.
Category: TransportLayerControl / PtpControl
PtpEnable
• type: Boolean
• default: false
• description: Switches PTP synchronization on and off.
Category: Scan3dControl
Scan3dDistanceUnit (read-only)
• type: Enumeration, is always Pixel
• description: Unit for the disparity measurements, which is always Pixel.
Scan3dOutputMode (read-only)
8.1. GigE Vision 2.0/GenICam image interface 121