Technical Specs

1 Introduction

Revisions

This product may be modiﬁed without notice, when necessary, due to product improvements, modiﬁcations, or

changes in speciﬁcations. If such modiﬁcation is made, the manual will also be revised; see revision information.

Documentation Revision 1.8.1-2-g3c019b5 Dec 12, 2019

Applicable to rc_visard ﬁrmware 1.8.x

This manual and the product it describes are protected by copyright. Unless permitted by German intellectual

property and related rights legislation, any use and circulation of this content requires the prior consent of Robo-

ception or the individual owner of the rights. This manual and the product it describes therefore may not be

reproduced in whole or in part, whether for sale or not, without prior written consent from Roboception.

Information provided in this document is believed to be accurate and reliable. However, Roboception assumes no

responsibility for its use.

Differences may exist between the manual and the product if the product has been modiﬁed after the manual’s

edition date. The information contained in this document is subject to change without notice.

Indications in the manual

To prevent damage to the equipment and ensure the user’s safety, this manual indicates each precaution related to

safety with Warning. Supplementary information is provided as a Note.

Warning: Warnings in this manual indicate procedures and actions that must be observed to avoid danger of

injury to the operator/user, or damage to the equipment. Software-related warnings indicate procedures that

must be observed to avoid malfunctions or unexpected behavior of the software.

Note: Notes are used in this manual to indicate supplementary relevant information.