Instruction manual

• Drill ø 8 mm holes at all the centre points marked.

• Insert the wall plugs 11 in the holes.

• Fix the brackets using the 12a screws supplied.

• Fix the back panel (where present) using the 12a screws supplied.

Mounting the hood body

Connections

DUCTED VERSION AIR EXHAUST SYSTEM

When installing the ducted version, connect the hood to the chimney using either a flexible or rigid

pipe ø 150 mm.

• Screw the two screws 12d supplied onto the

brackets 7.1.

• Hook the hood body onto bracket 7.1, centring it

around the vertical line.

• Use the adjusting screws 12d underneath the

hood to level the hood body.

• Fix the pipe in position using sufficient pipe

clamps (not supplied).

• Remove any activated charcoal filters.

7.1

12.d

ø 150