Operating instructions

5
Installation
Mounting the Rangehood
Fit the ducting adaptor to the rangehood using the short screws supplied.
Provide an opening on the underside of the cupboard to suit models/ provide 490mm x 258mm for 600 model or
665mm x 258mm for 900 model.
Remove the face plate of the rangehood by undoing the two visible screws located on both side-ends. Eight
mounting holes around the unit then are accessible.
Lift the rangehood and fit through the opening of the cupboard. Secure unit using long screws supplied. Refit face
plate.
Recirculation mode
1. This unit can be installed to operate in recirculation mode where ducting is not a chosen/desired or practical
option. Ensure that the top ducting outlet are not obstructed. Even a partial obstruction will restrict the
efficiency of the rangehood.
2. Replace aluminium filters with charcoal filters (Pg. 6 Parts & Accessories list).
Model may vary slightly from images pictured