RPA Issue:B Description: ROBINHOOD POWERPACK RANGEHOOD Model Numbers: RPA3CI6SS/WH, RPA3CI9SS/WH Model pictured: RPA3CI6SS/WH All dimensions in mm Model may vary slightly from images pictured 1
Overview Pre-installation Thank you for purchasing a quality Robinhood rangehood. Robinhood has a high standard of quality control and every rangehood is tested and approved before it leaves the factory. Important: o Please read the entire instructions before installing the rangehood. o Always switch power off prior to installation. o Stainless steel is very easily damaged during installation if abraded or knocked by tools. Protect the rangehood with the cardboard box or plastic bag during installation.
Pre-Installation - continued Ducting Options The method of ducting should be carefully considered before installing the rangehood. The guide below recommends the ducting components to use for all common ducting configurations - through the top of the home (for the roof and soffit) and through the rear of the home. 150mm round ducting should be used in conjunction with this model rangehood. Alternatively this rangehood can be operated in recirculation mode (see Recirculation mode Pg.5).
Pre-Installation - continued Installation position When installing the rangehood, the lower edge of the unit must be a minimum of 600mm (650mm for gas cooker) above the cooking range. The recommended position for the hood is 650mm above the hotplates. Pictured: Minimum height from the hob surface to the underside face of the rangehood is: 600mm for electric hob, 650mm for gas hob Notes: If the instructions for the gas hob specify a greater distance, this has to be taken into account.
Installation Mounting the Rangehood Fit the ducting adaptor to the rangehood using the short screws supplied. Provide an opening on the underside of the cupboard to suit models/ provide 490mm x 258mm for 600 model or 665mm x 258mm for 900 model. Remove the face plate of the rangehood by undoing the two visible screws located on both side-ends. Eight mounting holes around the unit then are accessible. Lift the rangehood and fit through the opening of the cupboard. Secure unit using long screws supplied.
Operating instructions Controls Light The light can be operated independently by sliding the light switch on/off despite the working status of the fan. Please refer to the icon on switch panel. Fan The fan is operated by sliding the power switch on. It can be run at three different speeds (Speed 1 / Speed 2 / Speed 3) depending on the cooking requirements. Please refer to the icons on switch panel. Cleaning and maintenance General Maintenance Switch off the rangehood before cleaning or maintenance.
Product approvals and ratings Product approval number V08376 Product rating 290W (1.21A) Max at 240V 50Hz Electric approval AS/NZS 60335.2.
Warranty Certificate (New Zealand) The benefits conferred hereunder are in addition to all other rights and remedies in respect of the product which the purchaser has by virtue of the Consumer Guarantee Act and similar legislation, and nothing contained in this Certificate shall in any way limit the purchaser's rights under such legislation. Terms and Conditions The following conditions apply in respect of the warranty given in this certificate: 1.
Warranty Certificate (Australia) The benefits conferred hereunder are in addition to all other rights and remedies in respect of the product which the purchaser has by virtue of the Trade Practices Act 1974 and similar State and Territory legislation and nothing contained in this Certificate shall in any way limit the purchaser's rights under such legislation. Terms and Conditions The following conditions apply in respect of the warranty given in this certificate: 1.
