Issue 1 Description: ROBINHOOD ISLAND CANOPY CURVED GLASS 90CM Model Numbers: RIV3CL9G Product may vary slightly from the picture
Pre-installation Thank you for purchasing a quality Robinhood rangehood. Robinhood has a high standard of quality control and every rangehood is tested and approved before it leaves the factory. Important: Please read the entire instructions before installing the rangehood, always switch power off prior to installation. All electrical work must be done by a registered electrician in accordance with local and national electrical codes as applicable. For your safety, this product must be earthed.
Pre-installation •The canopy hood is designed for 2400mm or 2700mm ceilings. •The chimney is telescopic and is designed for hood installations between 650 to 750mm above the cooking surface. •Ascertain the desired installation height of the canopy hood. •Any installation above 750mm will compromise the extraction performance. •The air outlet from the motor requires 150mm round ducting which requires 170mm diameter hole in the ceiling.
Pre-Installation - continued Contents of packaging: Typical equipment required: 1 1 2 2 1 electric drill and screwdriver tape measure and spirit level step ladder duct tape (if ducting) jig saw (if ducting) ladder (if ducting) x x x x x rangehood packet of fasteners chimney pieces (upper and lower) support frames Installation and Operating Instructions Ducting Options The method of ducting should be carefully considered before installing the rangehood.
Installation Before drilling any holes check that the area behind the surface to be drilled is clear of any electrical cables, pipes etc. Fixing to a solid joist or 50mm deep truss is recommended. Whenever possible protect the hob top with cardboard or similar. 1. 2. 3. 4. Before commencement unpack the canopy hood and check that it functions correctly. Use a plumb line to mark the centre of the cooking surface on the ceiling.
Control Panel Timer switch Canopy hood will remain on a low, mid or high speed for 15 minutes to clear away all residual cooking odours before switching off automatically Cleaning and maintenance Particular care must be taken with the aluminium filters which must be periodically cleaned (at least every two months). Remove the grease filters and wash them either by hand using hot soapy water or in the dishwasher using mild detergent. Note- some discolouration of the frame may occur.
Product approvals and ratings Product approval number SGSEA/110866 Product rating 223W, 220-240 Volt,50 hertz Electrical approval AS/NZS 60335.2.
Warranty Certificate (New Zealand) Terms and Conditions The following conditions apply in respect of the warranty given in this certificate: 1. Parbury Pty Limited (“Parbury”) warrants the following Robinhood products against manufacturing defects and faulty materials, under normal use and subject to the exclusions in this certificate, for a period of: Rangehood - 24 months from date of original purchase for domestic use. Uniduct – 12 months from date of original purchase for domestic use.
Warranty Certificate (Australia) Terms and Conditions If you are a consumer under the Australian Consumer Law, our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure 1.