ICKIT Issue: 1 Description: ROBINHOOD IRONING CENTRE KITSET Model Numbers: ICKIT All dimensions in mm Model may vary slightly from images pictured 1
Overview view Pre-installation Thank you for purchasing a quality Robinhood ironing centre kitset. Important: o Please read the entire instructions before installing the ironing centre. o Should you be fitting a door to the enclosure holding this product, please be mindful of the position of all door furniture (hinges, handles etc). Specifically ensure the board will operate without obstruction.
Pre-Installation - continued Cabinet dimensions Thie Ironing centre is designed to fit a 400mm wide (368mm internal) kitchen/laundry cabinet. Please ensure your cabinet fits the following dimensions as shown below. Please take care when pre-drilling holes not to drill all the way through or damage the cabinet. The screws supplied with all kits are designed for 16mm thick cabinet panels. Different screws may be needed if the cabinet panels are less than 16mm thick.
Pre-Installation - continued Installation position 1. Pre-drill holes (2mm diameter) in the cabinet on both sides for the screws supplied as per diagram „A‟ (previous page). 2. Attach one height adjustment bracket to the cabinet using the screws supplied. 3. Insert the ironing board pivot rod and pivot stop into the attached bracket. While supporting the ironing board attach the other bracket to both the pivot rod and pivot stop. 4.
Installation 5. Position the back stop behind the pivot stop in the middle of the cabinet and mark out the hole position. Drill 4 holes, 2mm diameter for the screws supplied. Attach the backstop (see diagram below). NOTE: Failure to install the backstop will weaken the product 6. Attach board retainer using the two screws supplied.
Operating instructions The ironing board can swivel 180o and has three working heights. To adjust the board: 1. With the board in the horizontal position, hold the board with one hand near the base (not by the nose) and support the pivot rod with the other hand. 2. Adjust the ironing board to the desired position by lifting the board by the pivot rod (not by the nose) and moving it to the required height.
Important safety information 7 This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Young children should be supervised to ensure that they do not play with the appliance.
Warranty Certificate (New Zealand) Terms and Conditions The following conditions apply in respect of the warranty given in this certificate: 1. Parbury Pty Limited (“Parbury”) warrants the following Robinhood products against manufacturing defects and faulty materials, under normal use and subject to the exclusions in this certificate, for a period of: Rangehood - 24 months from date of original purchase for domestic use. Uniduct – 12 months from date of original purchase for domestic use.
Warranty Certificate (Australia) Terms and Conditions The following conditions apply in respect of the warranty given in this certificate: 1. Parbury Pty Limited (“Parbury”) warrants the following Robinhood products against manufacturing defects and faulty materials, under normal use and subject to the exclusions in this certificate, for a period of: Rangehood - 24 months from date of original purchase for domestic use. Uniduct – 12 months from date of original purchase for domestic use.
