User Manual

5
554228 Rev. E July 30, 2013
Setup
Figure 1
Important: To operate this equipment,
the owner must complete and mail
the MVAC Certication Form, and
technicians must be certied with the
Environmental Protection Agency (EPA).
Unpack the Accessory Kit
Unpacktheaccessorykitfromthebox,and
removetheplasticpackaging.Thekitconsistsof
• Acalibrationweight.
• Vacuumpumpoil,oilllercap,andtube.
• Servicehoses.
• Fourbottles—oilreservoir,oildrain,UVdye
reservoir,sparereservoir.
• Threerollsofpaperfortheprinter.
• Plasticpouchcontainingawarrantycard(tobe
completedandmailed),applicableMSDSsheets,
aservicecenterlisting,andanenvelopeofMobile
AirConditioningSociety(MACS)information.
Assemble the Dye Bottle and Oil Bottles
Oil Inject Bottle
1.DeterminethecorrectoilfortheA/C
systembeingserviced.
2. Unscrewthelidfromtheoilinject
reservoirandremovethepiston.
3.Fillthereservoirwithoilonlytothe
MAXFILLline.Overllingthereservoir
willcompromisetheo-ringsealand
maycauseairtobeinjectedintothe
vehiclesystem.
4.Spreadathinlmofoilonthepistono-ring(to
reducesealdrag),andinsertthepistonintothe
reservoir.Threadthelidontothereservoir.
5.Slowlypushthepistonintothereservoiruntil
youseeoilattheconnector.
6. Inspecttheoilreservoirbottletoensurethereare
noairbubblesbetweenthepistonandtheoil—
pistonshouldbeindirectcontactwithoilsupply.
7.Holdtheassemblybytheplasticbottle,and
inserttheconnectorintothemagneticcoupler
ontheunit.
8.I nspectthebottleagaintoensuretherearenoair
bubblesbetweenthepistonandtheoil—thepiston
shouldbeindirectcontactwiththeoilsupply .
Oil Drain Bottle
1.Holdtheoildrainbottlebytheplastic
bottle,andinserttheconnectorintothe
magneticcouplerontheunit.
Dye Inject
Oil Drain
Oil Inject
Oil Drain
Bottle
Oil Inject
Bottle
UV Dye
Inject Bottle
Magnetic Couplers