User Manual

24
Maintenance
Inspect the unit periodically for
leaks. The manufacturer does not
reimburse for lost refrigerant.
Adjust Tank Fill Level
Whenconnectedtoarefrigerantsource,theunit
maintainsadefaultvalueof15lbs.ofrefrigerant
intheinternalstoragevessel.Thisvaluemaybe
adjustedupordowntosuittheapplication.The
minimumvalueis4lbs.;themaximumvalueis
17lbs.
1.SelectSETUP MENU.ScrolltoADJUST
REFILL DEFAULT andselectSTART.
2.Theunitdisplays
15.00LBS.
ENTERTHEAMOUNTOFREFRIGERANTTHAT
THETANKFILLFUNCTIONSHOULDMAINTAIN
INTHEINTERNALSTORAGEVESSEL.
MAX=17.00LBMIN=04.00LB
SELECTSAVETOACCEPTOREXITTOABORT.
3.SelectSAVEtoacceptthedefaultamount,or
usethekeypadtoenteranamountandselect
SAVE.
Check for Leaks
Checktheunitforleakseverythreemonths,oras
speciedbylawinyourjurisdiction.
1.Turnoffthemainpowerswitch,anddisconnect
thepowercordfromtheoutlet.
2. Openthereardoor.Removethetopcoverand
thefrontpanel.
3. Usealeakdetectortoprobeallconnections
forrefrigerantleaks.Tightenttingsifaleakis
indicated.
4.Reassemblethebodypanels,andclosetherear
door.
Replace the Printer Paper
1.Presstheovalbuttonatthetopoftheprinterto
releasetheprintercover.SeeFigure16.
2.Graspthetabsandpullthecoverofftheprinter.
3.Removethepapercore.
4.Installthenewrollofpaperwiththeendofthe
paperatthetopoftheroll.
5.Assemblethecoverontotheprinterwiththeend
ofthepaperovertheroller.
Oval Button
Tab Tab
Paper Feed
Figure 16