User Manual

13
554228 Rev. E July 30, 2013
Operating Instructions
Recharge the A/C System
1.Connectservicehosestothevehicle’sservice
ports.
2.SelectCHARGE.Thedisplayreads
CHARGEMENU
CHARGEAMOUNT:0.00LB
CHARGEMODE:______SIDE
USEARROWKEYSTOSCROLLUNITS.
3.Atthispoint,selectINJECT OIL,ifnecessary.
Thedisplayreads
OILXXX
INJECTDYE_______
 Usethenumberkeystoentertheamountofoil
toinject.
4.SelectTOGGLE DYEtoturndyeinjectON
orOFF.SelectSAVEtoreturntothecharge
screen.
5. SelectMODEtotogglebetweenahigh-sideor
low-sidecharge,orboth.Note: Charge mode
after injecting oil allows only a high-side charge.
6.Typeinachargeweightusingthenumberkeys.
SelectSTART.
 Movingorbumpingtheunitatthispointmay
resultinaninaccuratecharge.
Note:
• During a charge cycle, if the unit fails to transfer
refrigerant due to low tank pressure, the charge
process is automatically interrupted and the unit
operates in a mode to build tank pressure. Once
tank pressure is sufcient, the unit automatically
completes the charge.
• When the charge cycle gets close to the weight
entered in Step 6, the unit slows down. It will
charge, settle, charge again, settle, etc.
• Before it charges, the unit may purge air
out of the ISV to minimize the amount of
noncondensable gases that could contaminate
the A/C system.
Operating Tips
• After selecting the CHARGE function and
entering a desired weight, if the weight entered
will leave less than 2 lbs. (.91 kg) of refrigerant
in the internal tank after charge, the charge
function will not start. The display reads
INSUFFICIENTREFRIG.
THEREISNOTENOUGHREFRIGERANTIN
THEISVTOCOMPLETECHARGE.
PRESSTANKFILLTOADDMORE
OREXITTOABORT.
Refer to the Maintenance section for
instructions to Manually Fill the Internal
Storage Vessel (ISV).
• After selecting INJECT OIL, if the oil inject
bottle is not in the correct position, the display
reads
INJECTOILBOTTLEWEIGHTISLOW
CHECKOILBOTTLE
RETRYOREXITTOABORT
Verify the oil inject bottle is attached to the
machine as explained in the Setup section.
• After selecting INJECT OIL, if there is an
insufcient amount of new oil in the oil inject
bottle, the display reads
INJECTOILHASSTALLED
CHECKOILBOTTLE
RETRYOREXITTOABORT
Fill the oil inject bottle with new oil as explained
in the Setup section.
• If pressure is detected, the unit displays
PRESSURETOOHIGHFORINJECT!
PRESSEXIT
Select EXIT, and recover refrigerant before
proceeding.